SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

MACHINE for corn sticks

MACHINE for corn sticks MACHINE for corn sticks
MACHINE for corn sticks intended for forming corn sticks of maize grain by thermal and mechanical processing. SPECIFICATIONS Productivity, kg / h, not more ...................................... 10 The frequency of screw rotation, min-1 .............................. 640 Number of holes in the head ......................................... 1 Rotational speed of the knife, min-1 ................................ 1450 Motor drive screw: - Rotational speed, min-1 ........................................... 1450 - Power, kW ......................................................... 7,5 - Supply voltage, V ......................................... 380 (50 Hz) Dimensions, mm, not more .................................... 1000h700h800 Weight, kg, max ............................................. 300 DESIGN AND PRINCIPLE OF PLANTS On the bottom plate (item 2) frame (Item 1) is installed an electric motor drive screw and cutting mechanism (detail), connected through belt drive with a shaft bearing housing (Item 5). On a bed also located control panel (item 4). The body is a shaft bearing (item 3), rotating in the radial ball bearings. For the perception of the axial load on the form screw (item 7) installed in the housing thrust bearing. To his flange body fastened to the cylinder liner (Item 6), the opposite sxigeis attached to the cylinder head (Item 8) with a hole for exit corn veins. The front end of the head is a mechanism with a rotating cutting knife (Item 9), whose motion occurs through a belt transmission by an electric motor. Preheating the corn mass comes from the outside heat source. Over the cylinder mounted hopper for the reception of maize grain. Corn grits from the hopper through an adjustable flap comes the cylinder, where the press and heated to 145? S. As a result of exposure to heat, humidity and pressure, it becomes a plastic mass which is extruded through the screw hole head. When you exit the hole mass under the action of steam, formed from superheated water, swells, it turns porous crunchy living. Knife divides the conductor coming out on sticks.
©2010-2017 Сайт Николая Русина.