Produce a differential in the dismantling of the below
A. Remove the differential bearing puller with
Two. Attach the differential with the driven gear in a vise.
Unscrew and remove the bolts securing the driven gear.
Three. Light strikes a wooden or rubber mallet
Remove the driven gear box with the differential.
4. Hammer with a small beard knock pin, latching
finger satellites. Remove your finger and satellite gear.
The order of assembly of the differential is as follows.
A. Dip the gear axes and satellites in the engine oil.
Gear thrust washer with the semi lay in the nest box.
Two. Through the openings in the box lay a differential satellite
on poluosevye gears so that when they are engaged with the
poluosevymi gears finger satellites could freely
pass through both the satellite.
Three. When not changing the mesh, turn the satellites
simultaneously with poluosevymi gears so that the satellites
included in the spherical cavity to shift boxes
finger holes satellites.
4. Put your finger satellites so that the hole under the
locking pin coincided with a corresponding hole in the box.
Five. Zapressuyte pin until it stops, and the edge of the hole in the box
zakernite necessarily to in-service
the pin that holds the finger could not be thrown away.
After assembling the gear should rotate in the application of a force,
noxtexceeding 2 kgf-m.
Permissible axial clearance gear axis 0.30 mm. At
appearance of a large axial clearance is recommended
beneath the pinion axis additional thrust washers
(Fig. 110) to eliminate the gap, to avoid overloading
adjustment of the gears on the axis must be the same.