SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Removal, disassembly and reassembly of ball bearings

Ball joint (Fig. 138), remove from the vehicle for inspection or repair only when a knock is heard at work suspension while moving obstacles on the road. Removal of ball bearings make in that order. A. Install a safety tie between the lower arm and the cross-bar suspension (see Fig. 125). Two. Remove the wheel. Three. Straighten the cotter pin 15 (see Fig. 123) and pull it out of the hole, Loosen the nut 17, it is not turning out. 4. Install the device (Fig. 139) for Extrusion finger Ball bearings of the tapered hole so that it at one end included in the opening of the upper rack bosses, and others - center hole thumb ball joint (Fig. 140). If you can not relax in a cone tip toe through the rotation screws, a hammer is allowed to the speaker of the flange devices to dislodge his finger from the conical hole. Five. Loosen the bolts 13 (see Fig. 133) mounting supports and curve balls remove it from the lower arm. If there is support in the ball moving a finger along the axis of more than 6 mm, it must be disassembled for replacement of worn parts. Disassembly easier to produce in a vise. Notice. The design of ball joint allows for axial movement finger up to 2.5 mm After removing the cover all the parts, remove the ball bearing from the housing and inspect. Worn and damaged parts, replace new. Bearing assembly in the reverse order. Tightening torque of screws 15 fastening bolts 13 to the lower spurs of ball lever must be equal to 2-2.5 kg-m. Москвич-412 Москвич-412 Москвич-412 Москвич-412
©2010-2017 Сайт Николая Русина.