SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REAR SUSPENSION
DETERMINATION OF TECHNICAL REAR SUSPENSION

Springs car with a body "sedan" and "combi" collected from the use of plastic and rubber gaskets mezhlistovyh pads on the clamps and do not require lubrication. Spring Car "box" with no gaskets to eliminate creaking sheets need mezhlistovom cmazyvanii. Check the height of spring. With a fully loaded vehicle (gross vehicle weight), the gap between the buffer compression and spar floor (Fig. 151) must be at least 10 mm for cars IL Model 21 251 and "Moskvich 412IE" not less than 35 mm for cars IZH models 2715-01, 27151-01 and 27156. The smaller the gap, resulting from precipitation springs or wear rubber bushings, is unacceptable. Identification of precipitation of one of the elastic elements suspensions. Implementation of this work is described in Sec. "Methods of detection of shrinkage spring front suspension. " Check the status of joints and rubber washers protivoskripnyh. This check is carried out by visual inspection of parts. Москвич-412
Статья взята с сайта
©2010-2017 Сайт Николая Русина.