SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR REAR SUSPENSION
Removal and installation of replacement springs and rubber bushings

Removing the spring produce in the sequence listed below. A. Lift the rear of the car jack, put the box, remove the jack and remove the wheels. Two. Rasshplintuyte and unscrew the nut 21 (Fig. 152) of the lower finger the shock absorber mount, remove the clip 20 and the rubber bushings shock to the finger pads ladders. WARNING! Do not pull the lower end of the shock absorber back more than is required to remove it with a finger, to avoid bending the rod. Three. Loosen the nut 10 ladders, remove the spring washers 17, plate 16 ladders and rubber buffer 13 compression. 4. Several lift jack with the rear axle to completely unload the spring. Five. Loosen the nut finger front bracket of the first spherical washers 5, and then at the other end, remove the nut and remove the front pin 7 and washers from the mounting bracket holes 3 and lower the front end of spring. 6. Loosen the nut 10 fingers cheek earrings springs and washers cheek and ear-rings 11. 7. Remove the cheek 9 earrings, complete with finger holes of the spar and remove the spring. Eight. Remove the four rubber bushings from the spring and Ushkov spar holes. The installation of springs on the car make in obratnom order given the following instructions. A. When mounting the front spring eye bushing second rubber insert the eye through the hole in the bracket 3 for spherical washers. Distance among plates cheeks bracket should be 57 mm. The first nut should be tightened finger, located on the part of Small holes bracket. Spherical washers 5 fold bulges and set out in the opening bracket. Tightening torque of nuts finger from the spherical washers should be equal to 4.5-6 kgcm. Finger tighten the nuts evenly to avoid dxistortion of rubber bushings and bending cheek earrings. The final tightening of the nuts finger rings produce spring-loaded weight of the car body (Specifically load the car should not be). This will provide the greatest the life of the rubber bushings. Nuts 10 ladders finally tighten at full load in the back of the car, torque 5-5.5 kgcm (no more). Москвич-412
©2010-2017 Сайт Николая Русина.