SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Disassembly and assembly of springs

Disassembling the spring is made to replace it destroyed sheets. Procedure for removing springs from the vehicle listed above. Dismantling in the following order. A. Hold down the middle part of the spring in a vise with nekalenye sponge. WARNING! Do not wrench the nut without spring centering bolt fixing it in a vise, as in the spring plates are assembled with preload. When removing the nuts, they abruptly straightened which can lead to injury. Two. Straighten hose clamps. Three. Remove the nut and bolt centering, parting gripe dissolve spring. Spring assembly in the reverse order. In expedient to use the assembly rod 08 mm and length 200 mm, to insert in the center-bolt holes in the sheets springs. Under compression spring in the grip bars provide the specified match sheet over the hole under the center-bolt. Then, instead of Insert the bolt rod centerline of the indigenous leaf and tighten , after which spring can be removed from the grip. Bending the clamps do with a hammer.
©2010-2017 Сайт Николая Русина.