SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Removing and installing the shock absorber rear suspension and replace the rubber bushings

Removing the shock absorber make in that order. A. Place the car on a pit or hoist. Two. Remove the cotter pin 22 (see Fig. 152) of the lower mounting nut finger damper, unscrew the nut 21, remove the clip 20 and the mounting eyelet of the shock absorber from the finger plate 16 ladders. Three. Loosen the nut of the upper shock absorber mount, remove the spring washer, remove the screw 29 and remove the shock absorber. 4. Remove the spacer 28 and the four rubber bushings 19 of the upper and lower mounting lugs damper carefully. inspect and replace worn out. The installation of shock absorbers on the car in reverse sequence. WARNING! When removing and installing the shock absorber is not allot the lower end of the shock absorber back more than is required for removing it from the finger pads ladders to avoid bending the rod.
©2010-2017 Сайт Николая Русина.