SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

TROUBLESHOOTING GROMMETS and remedies

-------------------------------------------------- ----------------- Cause of Failure Solution -------------------------------------------------- ----------------- absorber leaking, leaking fluid The weakening of tightening the nuts reservoir ................................ Tighten the nut tank ................................. Damaged or worn rubber seals rod ...................... Replace the rubber cuff ................................. Damage to the stem, the presence on its surface, deep scratches, nicks, and corrosion ................ Replace the rod. shock absorber piston rod moves freely (without effort) in the early course of tension or compression, and it is not eliminated by pumping The reduced amount of fluid in the shock ..................... ................................. Check the amount of fluid and add if necessary Shock resistance does not develop sufficient tensile Leaky valve in the return result of contamination or damage its parts ...................... Disassemble valve, flush the disks and piston, replace damaged discs The decrease of the spring return valve ........................ ................................. Replace the spring, or between her butt nut and washer, place an additional adjustment Leaking pressure relief valve piston ........................ ................................. Clean and check the valve ring Shut-off edge at the ends of the piston. If they have small bumps, ends of the piston is slightly grind on a flat cast-iron stove, and when significant irregularities, replace the piston Wear, leading to increased fluid flow over gaps or risks of a deep worn piston rings and ......... Replace worn parts .................................. Shock does not develop sufficient resistance to compression Leaky valve compression as a result of contamination or damage its parts .......................... Disassemble the valve assembly and the compression rinse, replace damaged parts The decrease of the spring compression .................................. Replace spring or .................................. between her butt nut and washer, place an additional adjustment Leaking intake valve ................................... ................................. Wash and grind the intake valve, as indicated for the relief valve The weakening of tightening the nut container .................................. Tighten the tank ................................. Shock develops resistance to excessive compression at the end Excessive amounts of fluid in the shocks ........................ Remove ............................... excess fluid in shock with a sharp movement of the rod are observed knock and seizing The weakening of tightening the nut container .................................. Tighten the nut of the reservoir .............................. Sticking piston moves tension and compression ........................ .............................. Pick another position of the piston in stock Bend the stem ................... Replace the rod
©2010-2017 Сайт Николая Русина.