SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

TROUBLESHOOTING STEERING and remedies

-------------------------------------------------- ---------- Cause of Failure Solution -------------------------------------------------- ---------- Increased travel of the steering wheel (More than 25 mm when measured at the rim - about 7 °) Increased clearance in the joints and tie rods front suspension Tighten the wheel .......................... joints or replace worn parts Violation of backlash adjustment worm in engagement and roller or increased wear combs clip and cutting the worm ........................................... Adjust ............................... lateral clearance in gearing or replace worn parts Violation of the worm bearing preload adjustment or wear bearings and cones worm ............................... Adjust the tightness ............................... bearing a worm or replace worn parts The increased axial movement of the shaft pitman arms ............ Replace worn parts ............................... Worn bushings pitman arm shaft ........ Replace worn parts Weak tightening nuts fry ........................ Tighten the nut ............................... Free lift shaft on the steering wheel Weak tightening nut steering wheel ........................ Tighten the nut ............................... Axial worm, felt in the steering wheel Violation of the worm bearing preload adjustment ............ Adjust the tightness of bearings ............................... radial movement of the shaft of steering control, perceived on the steering wheel Wear of the bearing shaft steering ..................... Replace the bearing .............................. The weakening of the bolts attaching the steering column ........... Tighten bolts .............................. jam in the steering gear Improper adjustment of backlash in the gearing worm and roller bearings, or tightness worm ....................... Adjust the steering .............................. Large wear clip or worm .............................. .............................. Replace roller or a worm Scrape or clicking in the steering Lack of lubricant ............................... Check the tightness of seals .............................. shaft and pitman arm steering shaft and fill the crankcase lubricant The destruction of the working surfaces of a worm or a movie ............ Replace worn parts .............................. Separation of mounting sleeves of gear from the frame ..... Weld the sleeves by electric .............................. enshrined in the steering mechanism The presence of metal shavings or sawdust in the crankcase ............ .............................. Drain grease, Rinse and fill the crankcase with kerosene fresh grease leaking oil from the crankcase steering IEI shaft sleeve bipod or damage to its working edge the assembly ................... Replace shaft sleeve bipod The weakening of the lock nut, adjusting nut bearing worm ..................... Tighten the lock nut, and if it does not eliminate the leak, set between the nut and the end of the crankcase cardboard or aluminum plate Scrape the top of the steering column The weakening of the bolts attaching the steering column .................. Tighten bolts .............................. Grazing the steering column housing ............................. .............................. Release column and set the the gap between the housings and steering wheel The absence of the gasket between the steering column and bracket attachment to the body of the column ................................... Place the rubber gasket ............................. Breaking steering shaft Misalignment of the shaft due to incorrect relative positions mating surfaces the crankcase mounting bushings steering mechanism on the frame and mounting bracket holes for the steering column to the body ............ Eliminate bias and set a new steering shaft weakening connection with the case of the steering column steering mechanism The weakening of tightening the clamp fastening the column to the crankcase ........ Tighten bolts ............................ clamp mounting column Lack turn the front wheels to one side Improper installation of pitman arms on the splines of the shaft ........ Set ........................... pitman arms on the slots shaft, aligning the marks provided on the ends of both parts
©2010-2017 Сайт Николая Русина.