1. Remove the flange bolts and driveshaft
pinion final drive, pull the drive shaft
back and remove from the vehicle.
2. Unscrew the nut shell speedometer flexible shaft
the mechanism of its drive on the gearbox and remove the nest
3. Unscrew and remove the bracket mounting bolt receiving tube
muffler to the bracket on the transmission housing.
4. Disconnect the traction drive transmission control of
levers on the side cover transmission housing.
5. Disconnect the intermediate lever parking
brake system with a bracket (rasshplintuyte and remove
fingers) and pull the thrust levers.
6. Remove the slave cylinder to clutch housing
7. Remove the flange nuts reception pipe muffler
to the flange of the exhaust manifold.
8. Substitute for the transmission housing or other jack
9. Loosen the bolts left and right front pillars
motor to the brackets of front suspension cross member.
10. Remove the two bolts fastening the rear engine mounts
(By extension) to a removable cross bar.
11. Remove the two nuts to the bottom cross body
and remove it.
12. With the lifting mechanism to lift the engine
The installation of the power unit to produce a car
the reverse sequence.