Removal, disassembly and assembly of the pendulum arm
Swingarm 16 (see Fig. 163) is connected with the right head
average thrust steering linkage with two fingers with an oval head.
Bracket 19 is attached to the pendulum arm spar 29 is similar
of gear in one long and two short 28 39
bolts and nuts 38 and lock washers 37. Under the heads of two bolts
planted a simple washer 25. Limitation of rotation of the inner wheel
by means of projections available at the swing arm and
fry, which are limited by the bolts 33 screwed into flange
Nuts 31 limiters 30, welded to the longitudinal members. Zakontrivayutsya
bolts with nuts Z.
If you wear sleeves pendulum arm can lift their npoizvesti,
without removing the pendulum arm from the vehicle. To do this, rasshplintovav
nut, tighten it up to the disappearance of tangible at the application
some effort in the hands of the gap and connecting zashplintuyte.
Removal and disassembly of the pendulum arm in the productivity of such
A. Raise the jack the right front of the car, lower
her on the stand and remove the right wheel. Two. Remove the bolts
pendulum arm lever to spar frame.
Three. Remove the pendulum rod with a cone finger thrust front (see above
Sec. "Disassembly and assembly joints steering gear").
4. Hold the pendulum lever arm in a vise and rasshplintuyte
Loosen the nut axis of the lever. Remove the washer with flat and plain washer.
Five. Shaking the lever, remove the axle from the bracket.
6. Remove the lower bushing and washer from the axis of the lever and remove the upper sleeve
from the opening bracket.
Assembly and installation of the pendulum arm of arbitrariness in the back
sequence. Before assembly, clean up the axis of the fine-grained
sanded. Tightening torque of the nut axis must be within
1 kgf-m (6,6-9,8 kg load applied at the end of the pendulum arm).