SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Steering gear assembly and install it on the car

Assembly and installation of steering components to produce the specified below the sequence. A. Insert the shank finger joints of lateral internal steering gear in the middle left tapered holes thrust, probably tighten (torque 6.5 kg-m) and zashplintuyte nuts. Two. Install the bracket on the right wing spar pendulum arm and tighten the mounting bolts a little nuts. Three. Insert the shank joints of fingers thrust in the middle left conical hole heads bipod and pendulum arm, screw, and tighten the nut zashplintuyte. Make sure that to the middle joint tie rod having xagreater height (In which the finger is set with an oval head), was added to the pendulum arm. 4. Insert a finger outer liners, joints in the cone opening lever steering linkage, screw, and tighten zashplintuyte nuts. Five. Raising or lowering the pendulum arm, pull the crown pendulum arm on a level with the head of the bipod, while average thrust located horizontally, and tighten the bolts mounting bracket to the frame of the pendulum arm. 6. After installing the tie rods and adjusting the front toe wheels, while maintaining a fixed position the front wheels, set parallel to the outer ends of the tip ends of the bosses, to which they are attached. Then, holding the tip and pegulirovochnye clutch from turning, tighten the lock nut adjusting clutches. At the end of the front wheel toe adjustment for fry, set out in the middle position, the straight movement of the vehicle, the steering wheel spokes should be located symmetrical vertical plane passing through the center. In the case of an asymmetric arrangement of the spokes, remove the steering wheel, set to the correct position and tighten the steering shaft mechanism.
©2010-2017 Сайт Николая Русина.