SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Repair brake master cylinder
Removal and disassembly of the brake master cylinder

Removal and disassembly of the master cylinder spend in the next sequence. A. Clean the dirt from the master cylinder, vacuum booster, and steel pipelines extending from the master cylinder. Two. Disconnect the piping from the master cylinder. Three. Remove the master cylinder by removing the two nuts to vacuum amplifier. 4. Remove cover from pan and drain the brake fluid. Five. Place the master cylinder tank down and pressing a few once the plunger 41 (see Fig. 172) of the first chamber, remove the brake fluid from the master cylinder. 6. Using a wooden paddle as a lever, remove the tank with the cylinder. 7. Remove the master cylinder housing connecting sleeve 30. Eight. Pliers with narrow and thin lips, remove the thrust pin piston of the second chamber. 9. Remove the retaining ring 44, using pliers. 10. Force of arms behind the piston shaft 41 first remove the privateers piston sleeves and spacers. The piston of the second chamber removed as well. Otherwise, the to retrieve the remaining items in the master cylinder should be blows from the butt-end of the cylinder of the first chamber of the clean slate push the piston through the first chamber and remove it. To remove the piston can also use compressed air. 11. Inspect and ensure perfect purity the cylinder and the working surface of the piston, in the absence of corrosion damage, scratches and other irregularities. To eliminate the defects on the mirror of the cylinder may be re- honing, but the diameter of the cylinder must noxtexceed diameter specified in the Table. 17. If the defects, causing a significant change in internal diameter cylinder, replace the new building. It is recommended at each disassembly to replace the master cylinder seals new, even if they are still in good condition. 12. Check whether the lost elasticity of the spring piston.
©2010-2017 Сайт Николая Русина.