SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Assembly and installation brackets

After checking and replacing the parts needed to start bracket assembly, which is in reverse order, taking into account the following additional guidance. A. The inner surface of the cylinder must be lubricated with fresh brake fluid recommended in Anal. Two. Two. Sealing ring channel bracket, O-rings cylinders and protective caps are subject to mandatory replacement with new ones. Three. O-ring cylinders and the outer surfaces of the pistons should be cleaned and lubricated with fresh brake fluid. 4. Pistons must be inserted into the cylinder with fingers. Application no tools are not allowed. Before installing the bracket on the car, set it on the flexible hose, with seal (copper washers), replace with new ones. When installing the bracket on the car, follow these conditions. A. Tightening torque of bolts holding the bracket and turning the steering lever harness must be equal to 8.7 kgf-m. Two. When you attach a pipe to flexible hose exclude the possibility of twisting the hose. Tightening of packing gland hose with clamp connections can be made only if the other the hose is not installed in the bracket. Warning! In the front hole (in the course of the car) bracket should strengthen the tip of a flexible hose from the larger cylinder bracket. After installing the brackets flush the system, as described in the Section.
©2010-2017 Сайт Николая Русина.