SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Replacing the brake pads

Pads should be replaced by new ones, if the thickness of the lining decreased to 3 mm. When removing the brake pads is recommended to mark them to in the subsequent assembly to put on the old site. Replacement pads with new produce in the below mentioned sequence. A. Straighten the bent ends of the pins 5 (see Fig. 173), remove pins and remove the pads. Two. Move the piston inside the cylinder, taking care not to damage the dust caps. Three. Put the new pads, install the cotter pins. 4. Secure the pins at one end otgibaniem an angle of 45 °.
©2010-2017 Сайт Николая Русина.