The sequence of operations like that.
A. Remove the wheel and brake drum.
Two. Remove both spring clamp blocks with special
mites (Fig. 187).
Three. Lift the end of the compression spring, remove the brake shoe.
4. When dismantling the brake pads rear wheels
perform additional operations:
- Remove the spacer bar pads;
- Remove the release lever tip of the cable drive parking
brake system;
- Disassemble the swivel release lever to the brake
block;
- Remove the lever.
Clean the brake pads are removed from the dust and dirt. Worn
Friction pads, replace with new ones.
Installation of the brake pads on a shield in reverse
sequence.
Pads during disassembly mark to the assembly to put them on
former places, as the ring of automatic devices
installed on a particular block and another block of
will need to move back to its original position with the piston.
Every unnecessary movement of the ring, dirt or the use of
inappropriate bars can lead to longitudinal scratches
on the mirror of the cylinder and the formation of a leak brake fluid.
When you install the pads with new friction pads pistons
insert and rotate by 90 ° and slide all the way from one to another
with the same distance from the ends of the cylinders. Shift produce
light hammer blows through a drift wood.