SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Repair of the pressure regulator

In order to verify the need for dismantling and repair of the pressure regulator, perform the following steps. A. Remove the load from the spring strut. To do this, disconnect the the lower hinge bracket on the rack, which is located on the beam rear axle, and by loosening the locking screw 1 (fig. 195), remove spring load, and then tighten the locking bolt. Two. Spend control braking on a horizontal section roads with a dry concrete surface. The load on the vehicle must be minimal (a driver). Inhibition of the rate of spending 50-60 km / h, gradually increasing the force on the brake pedal. Upon reaching the front wheels lock to stop further increased efforts on the brake pedal. Lack of rear wheel lock indicates proper operation of regulator. Москвич-412
©2010-2017 Сайт Николая Русина.