SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR OF SIGNAL DEVICES

To remove the alarm, it is enough disconnect the pipes, wires, and turn-key bolt holding the nut installed by the bracket. To disassemble remove the warning device switch 7 (See Fig. 175), take the ball three, then unscrewing the end fitting 8 and the cork 5, push the pistons 2 and 4. When removing the piston from the housing, be careful not to damage the mirror cylinder. For this purpose, using a wooden frame. When disassembling the signaling device replacement O-rings the piston is required. Details rinse and dry with compressed air. Make replacement of damaged parts. Assembly and installation of signaling devices in reverse order with the following additional guidance. A. Mirror of the cylinder, pistons and sealing rings with a thin brush a layer of fresh brake fluid recommended in Anal. Two. Two. Each piston is set to the appropriate side, not allowing passage of the O-ring through the hole under the ball in the Otherwise, the sealing surface of the ring will be damaged. Three. Managing grease lubricated ball DT-1. Control of the warning device is as follows. A. Connect the camera to one of the hydraulic drive, equipped with a manometer, the rest of the holes and stop the camera plugs (see ris.184). Another camera is connected to the environment. Two. Connect the test lamp in series, the battery battery and switch the alarm device. Three. Gradually increasing the pressure, fix the pressure at which the lamp. 4. Repeat the operation with a second camera (the first camera communicates with the environment). WARNING! Tests carried out only fresh brake fluid recommended in Anal. 2, the same fluid should be washed pipeline summing the reference pressure. Five. If the warning lamp lights up when the pressure within the 10,5-21 kg / cm and the brake fluid is not leaking out of the switch, set the alarm on the car. The cause of reduced pressure, giving effect to the signal device - the lack of tightness of seals due to wear of the cylinder mirror cuff or of poor quality. The causes of difficult change can be: - Failure of the switch; - Scratches on the mirror of the cylinder; - Swelling of the wrist; - Poor quality washing the cylinder. After eliminating the above-mentioned reasons alarm expose the re-inspection. After setting the alarm device on the car and the accession hydraulic piping, bleed the entire hydraulic system, as described in Sec. "Bleeding the brakes the system. "
©2010-2017 Сайт Николая Русина.