SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Bleeding BRAKING SYSTEM

Pumping the brake system for preventive produce replacement fluid for lopadanii air brake system and after the work-related discharge of liquid of the brake system. During the operation of pumping remember that the brake system has two independent circuits, of which combines a small cylinder clamps the front brake and rear brakes, and the second - the big cylinder bracket the front brakes. So pumped to a separate large upper cylinder brackets, and then the bottom bracket, small cylinders and the rear brake cylinders. Pumping the brake system make in that order. A. Fill the system with brake fluid recommended in Anal. 2, through the neck of the master cylinder reservoir. Two. Remove the front wheel, gently clean the dirt and dust from three air release valve bracket front brake. Three. Remove the rubber cap from the top valve 1 (Fig. 196) and Put on the head of the valve rubber or plastic hose drain the fluid. 4. Dip the end of the hose into a clean transparent vessel, partially filled with brake fluid and loosen 1/2 turn valve. Five. Repeatedly pressing sharply on the brake pedal pumped liquid from the system until such time until no liquid discharge from air bubbles and the resulting liquid is clear. 6. Hold the pedal down, tighten the valve. 7. Remove the hose, clean the valve and put an end cap. Eight. Repeat the operation for the second front bracket the brake mechanism. 9. Spend a pumping operation in the above sequence valves for cylinders 2 small clamps both front brake mechanisms, and then both rear brake cylinders. The operation was venting spend, checking each time the presence of fluid in both cavities of the master cylinder reservoir. In conducting the operation specified in the branches of the braking system appears pressure difference displaces the piston warning device, resulting in a lighted lamp. To bring the warning device to its original position Loosen the 1/2 turn a valve brake right or left wheels, having removed the protective cover, and gently pressing the brake pedal until you get to control lamp on the instrument panel went out. Then, while holding the pedal down, tighten the valve. The specified operation spend for all the released parking brake lever the system. Upon completion of operations to restore the required level in the tank. Liquid, fused with pumping, not re-use without preliminary, very careful filtration and removal dissolved air bubbles. If the bleeding of the brake system performed well enough, when you press the pedal at the end of its stroke will feel increased "Soft" pedal. Москвич-412
©2010-2017 Сайт Николая Русина.