Removal and installation of the bottom cover drive sprocket timing
Removing the cover nizhshey distribution of stars
made in case of repair or replacement of the crankshaft
shaft, timing chain and cuff replacement samopodzhimnoy
seal the front end of the crankshaft.
Removing the bottom cover is made of stars in such
- Loosen the nut stud fastening ignition distributor
and remove it;
- Loosen the nut mounting studs and remove the drive
Ignition distributor of the bore in the lower lid
distribution of stars;
- Bend the washer and remove the key-ratchet crank
- Remove the crankshaft pulley with a special puller
- Loosen the three mounting nuts and remove the full-flow oil
- Loosen the bolts fastening nuts deevyat and remove the bottom
cover the distribution of stars.
The installation of the bottom cover distribution of stars
should be done in reverse order, but necessarily
establish and strengthen the bottom cover before the top.