The order of installation is as follows.
A. Loosen the bolts fastening the rear bracket on the engine.
Two. Place the generator on the brackets and fasten two legs of the generator
bolts and nuts M10.
Three. Attach the third leg of the generator M8 bolt tensioning bar.
4. Attach the rear bracket bolts on the engine generator.
Five. Adjust the tension with the tension of the belt plate
in such a way that, when pressed in the middle of the belt force 4.3 kgf
it was a deflection in the range (8 ± 1) mm.
6. Connect the output wires '+' the generator to the battery and the load
the output of "W" on the brush holder - with the conclusion of the ignition switch, the case
generator enclosure engine.