SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Maintenance of the generator

To ensure safe and reliable operation of the generator in keep the generator operating in a clean and follow the rules maintenance. With daily maintenance vehicle check operation generator, as indicated by the ammeter after starting the engine when the battery Several empty starter. At the same time at an average speed crankshaft of the engine generator to provide charging current, the force which as far as restoring the battery charge decreases. With a working and fully charged battery no charging current (or a small force of the charging current) does not indicate failure of the generator. When servicing the vehicle check: - Tightness and if necessary tighten bolts generator; - The drive belt tension, adjust if necessary; - Tightness and cleanliness of all places joining the wires to the generator and the battery. If necessary, clean the place connections and tighten the nuts and bolts xcontact. At the next maintenance, follow these steps. A. Remove the alternator from the engine. Two. Blow the generator to remove dust. Three. Check the status of schedochnogo site. 4. Remove the two screws holding the cover to the integrated device cover and remove it. Five. Make sure there is free, and move the brush in the bezzaedaniya brush holder. In a difficult move brush brush holder Remove and clean, which loosen the two screws attaching the regulator. 6. Check the height of the brushes. The height of brush must be no less than 8 mm. 7. Check tightness of screws fixing the voltage regulator to the casing, tighten if necessary. Eight. Check the strength of welding flexible cords to the terminals and brushes voltage regulator. 9. Inspect the slip rings. If you wear xcontact rings greater than 0.5 mm in diameter, the generator must be taken apart and the ring pierced. The minimum allowable size of the slip ring grooves 28,5-0,28 mm. 10. Replace the ball bearings in the case of jamming or excessive noise. 11. Check and, if necessary, pull the pin generator generator pulley nut.
©2010-2017 Сайт Николая Русина.