A. Remove the two screws fastening device integral to the lid and
remove it from the brush holders and casing.
Two. Remove the two screws in the housing and remove the brush holder from the
integrated device, connected to flexible wires from the brushes.
Three. Unscrew the tie rods.
4. Remove the cover from the slip rings, together with the stator
if necessary, remove the lid remover.
Five. Disconnect the phase stator windings of the findings in the rectifier
block in the cover of the slip rings.
6. Remove the nut and the pulley with the puller remove the pulley.
7. Remove the fan, remote plug and unplug the feather.
Eight. Remove the cover from the drive shaft of the rotor using the puller.
9. Remove the four screws and ball bearing holder vypressuite
ball out of the slot cover from the drive.
The order of operations in the assembly of the generator - the reverse.