SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

GENERATOR TROUBLESHOOTING and remedies

-------------------------------------------------- ----------------------- Cause of Failure Solution -------------------------------------------------- ----------------------- generator does charging current, the ammeter shows the strength of the discharge current at an average speed of the engine crankshaft Slipping drive belt ............ Tighten the drive belt, Make sure that the ball Fault in the wiring or xcontact connections to the generator and other circuit elements .......................... Locate faults in Wiring or ground pin connections and correct the problem. Poor xcontact with the motor housing of the generator No xcontact between brushes and rings ............................. Check ........................................ brush assembly Sticking brushes in their guides ...................................... ........................................ Clean brushes and brush holder Worn brushes ............................. Replace the brush Contamination and lubrication ring ........ ring Wipe with a cloth soaked in gasoline, and if contamination is not removed in this way, ring sanded smooth out Poor xcontact of an integral unit with the housing of the generator, brush holders and cover ............... Check and, if necessary, Tighten the screws to the casing of an integral unit and cover generator Faulty battery .................................... Check ........................................ and, if necessary, replace the battery Failure of an integral unit JA112A .......................... Remove ........................................ integral device set instead of the generator brush holder type 1250 and check efficiency of the generator. If the generator is working properly, replace the integral device Tap the ends of the rings or open field coil ................... Remove ........................................ integral unit and check the resistance of the coil circuit between the xcontact rings. If you tap - Sealed, when the rotor is broken, replace Fault (interruption or breakdown) diode rectifier unit ........... Check ........................................ and, if necessary, replace the rectifier unit Interruption or short circuit in the phase of the stator ............................. Disassemble ........................................ generator, remove the stator and check the resistance of the phases. When the stator is good to be the same (the difference is not more than 10%). If you break or short circuit of one of the phases of the stator, replace Arrow ammeter off scale. A large force of the charging current Failure ................ Replace the ammeter ammeter Failure of an integral unit ................................ Replace the integral unit ....................................... Faulty battery .................................... Replace the battery ....................................... Noise ball Excessive tension or bias belt ....................... Adjust the tension of the drive ....................................... belt and remove the bias Worn or damaged bearings ................................. Replace the ball .......................................
©2010-2017 Сайт Николая Русина.