SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Check and adjust drive starter

Check and, if necessary, and adjust drive starter made as follows: in the off position, check the starter 34 1.5 mm distance (see in Fig. 205) from the flange end cap to the drive gear. the setting of the distance, if necessary, produce an adjusting screw 18 the drive lever 11 in a weakened kondrgayke; After checking and adjusting the starting position of the starter drive gear in the OFF position, the pressure on the lever 11 (after removing the protective housing 10) to lock the drive is moved in the direction of turn and produce verification of stroke when you switch gears. We adjusted correctly the gap between the end of the starter drive gear and turned hard sleeve to be (4.5 0.5) mm. Gap anchor light must be installed otzhatie it to the side of the collector. When necessary, the setting of the clearance by turning the studs 9 anchor the relay, which is first necessary to remove the cotter pin and axle lever. If overvalued gap adjusting screw pin, while undervalued - turn out.
©2010-2017 Сайт Николая Русина.