SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

TROUBLESHOOTING and remedies

-------------------------------------------------- ------------------------- Cause of Failure Solution -------------------------------------------------- ------------------------- starter does not turn on Violation of xcontact in the food chain starter due to corrosion or poor tightening the wire tip .............................................. Inspect the food chain .................................... starter smooth out and tighten all the clamps Faulty starter relay (open windings, grabbing, displacement of the xcontact disk) Short circuit in the starter ....................................... Check the operation .................................... starter relay and correct the problem Short circuit in the starter .............................................. Replace the starter ................................... The absence of a reliable xcontact in the ignition switch ...................... Check the ignition switch ................................... using test lamp connected to terminal 50 and the switch to the masses. At there is no voltage at terminal 50 in a position corresponding to the inclusion starter, the xcontact portion of the ignition switch replace When the starter motor rotates the crankshaft slowly A cold engine (unheated) Warm up the engine ............ Discharge or failure of the battery ........................ Check the battery ........................................ battery. Recharge or replace the fit, if the battery is defective Violation of the xcontact brushes with the collector (of your brushes, podgar collector) ............................. Remove the starter from the engine and dismantle it. If necessary, smooth out, or pierced reservoir, replace the brush, adjust the spring tension of brushes, as shown below Anchor the starter spins but the starter does not crank the crankshaft Slipping clutch starter drive ......................... Replace drive ........................................ starter, drawing attention to the safety of adjusting washers on the neck of the starter Tight walking on the drive shaft of a screw thread ............................. Wash ........................................ thread shaft and lubricate engine oil When the starter audible gnashing of gears starter, which is not engage Nick in the teeth of the flywheel rim .......... Repair nicks If adjustments are pinion drive and turn the moment xcontact closure Adjust the switch ............................. course of the drive gear and the time of closing the main xcontacts traction relay When the starter is heard repeating the sound of pulling relays and gears of the flywheel. Crank the engine will not turn The absence of a reliable xcontact between the clamp and the tip wires especially in the battery ............ Check and tighten the mounting tips of the wires to the terminals Break the chain holding the starter relay coil hauling .................... Replace the starter relay ........................................ starter after starting the engine does not turn off Sticking to the drive shaft of the starter armature or sintering xcontacts traction relay ........................... Stop the engine, remove and Disassemble the starter and remove the cause of seizure Sticking ignition switch .......... turn the key of the Force position corresponding to the inclusion of starter Interturn short circuits the starter relay coil ................................. Replace the starter relay ........................................
©2010-2017 Сайт Николая Русина.