SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Disassembly and assembly of the ignition switch

Removal of the ignition switch to the steering column make in the case a malfunction in the mechanism of the lock, the steering shaft locking management. Removing the xcontact device of the lock sleeve produce without removal of the ignition switch to the steering column. Removal of the ignition switch to the steering column produce in that order. A. Disconnect the "mass" wire from the battery. Two. Insert the key into the ignition switch to position 0 ("Off"). Three. Disconnect the electrical wires from the switch terminal xcontact device ignition. 4. Remove the four bolts and drill out the switch mounting bracket ignition on the steering column. Remove the lid of the container and mounting bracket the ignition switch. Five. Remove the three screws from the bracket mounting the ignition switch, Remove the spring washer screws. 6. Remove the ignition switch from the bracket, sinking a flat spring screwdriver to set the gap between the sleeve and the bracket with a hole side pin terminal xcontact device. The installation of the ignition switch in the bracket with a lock on the steering column in the reverse order. It should be noted that installation of the lock into the bracket is only possible in the position of key ignition switch "OFF". Removal and disassembly xcontact device make in that order. A. Remove, using a screwdriver, snap ring, the locking pin device in the pocket of the castle. Two. Remove the cartridge from the xcontact device. Three. Remove the washer from the castle shank pin device, disconnect mobile and immobile parts of the xcontactor and remove the drive shaft pin device. The assembly of the ignition switch xcontact device in reverse sequence.
©2010-2017 Сайт Николая Русина.