SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Disassembly and assembly of the piston connecting rod

Disassembly of the piston rod to make in this the sequence. 1. Remove the circlip holding the piston pin a boss, poddevaya each of them a small screwdriver. 2. Heat the piston, immersing it in 2-3 minutes in a vessel with water at 45-75 * C. 3. Vypressuyte piston pin from the piston with a hammer through a brass frame. Shatkna assembly with the piston in reverse the sequence. It is necessary to pay attention the following. 1. In the case of replacing one of the rods must be matched by weight and size of the hole in the piston pin. 2. Difference in mass between the heaviest and the lightest rod in the set, placed at the engine, not should noxtexceed 8 grams Belonging to a particular rod mass group marked with paint or a risk to the high tide of his cap. 3. The clearance between the piston pin and connecting rod bushing, belonging to the same size group (having the same color coding), check the following: piston pin should enter smoothly into the hole plugs under the force of right thumb, as shown in Fig. 23. Moskvich-412 Within this size group planting details piston pin in the sleeve connecting rod made with a clearance of 0.0045-0.0095 mm. 4. When assembling the piston connecting rod and piston pin Always check: coincidence otmnchennyh earlier number of cylinders on the pistons and rods, the coincidence of the direction arrows embossed on the bottom of the piston, with projections on the body and the connecting rod on the lid.
©2010-2017 Сайт Николая Русина.