SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

TROUBLESHOOTING Windshield wiper and washer and remedie

-------------------------------------------------- ------------------------- Cause of Failure Solution -------------------------------------------------- ------------------------- When wiper does not work Hang brushes and scorching collector armature motor ........... ........................................... Remove the wiper, Disassemble motor and repair Fuse due to jamming of the levers sticking in gear or malfunction of the motor ......... Find the cause and correct fault Wiper blades operate at a speed Faulty switch or resxistor .................................. Replace the faulty switch ........................................ or resxistor wiper does not work in continuous mode (The working position of the switch III) Poor xcontact wires to the control unit .............................. ...................................... Preload wire lugs Faulty control unit Replace control unit ......... Combustion safety washer ...... Replace the fuse Off wiper and washer after releasing the handle Switch Faulty control unit Replace control unit ......... washer works when you switch hands, and windshield wipers will not turn on Fault relays wiper .............................. Replace the relay ....................................... Faulty control unit Replace control unit ......... Electric washer stops at the same time wiper motor Faulty control unit Replace control unit ......... washer does not work with good wiper Malfunction or absence of a washer washer fluid in the tank ................................ Check and fill washer system fluid Blown fuse washer ...................................... Replace the fuse ...................................... After turning the wiper brushes are not set in the bottom (horizontal) position on the windshield Violation of regulation mechanism samoostanova ................................ ...................................... Remove wiper, unscrew the nut fastening the xcontact tavern, and by moving the last, until you get stopped brushes in the correct position. At the end of this adjustment, tighten nut xcontact booths During the strike the brush wiper seal Windshield The weakening of nuts or wrong brush lever installation of instruments ..................... Set the correct levers brushes. When installing the wiper arm on the rollers, brushes should be at a distance of 50-60 mm from the windshield seal
©2010-2017 Сайт Николая Русина.