SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Removing and installing crankshaft

Dismantle the crankshaft from the cylinder must performed on the engine, from which previously removed head cylinders, oil sump, the upper and lower covers the distribution of stars, the drive train timing, the back cover and sleeve cuffs with pistons and connecting rods. The sequence of operations is as follows: - Loosen the nut bolts fastening covers all five indigenous and remove the bearing caps with liners and thrust average cap rings; - Remove the crankshaft and bearings from the block. Laying the crankshaft into the block in reverse the sequence. In this case, do the following: - Before laying in the bed of the shaft power lay ear, brushing working surfaces with oil, applied to the engine; - Lay the shaft and set into place with the lid liners which should also be oiled. When you install caps into place obey the order of the lids in accordance with the number embossed on the cover of each site. Account numbers of lead covers the front end of the block where and should be sent to the sharp part of the grounds, where engraved serial numbers on the lids; - When the middle block on the cover of Face grooving Set backup rings, smazashshyn oil for the engine; - Tighten bolts attaching the crankshaft bearing caps moment of 11.0-12.0 kg · m using necessary torque wrench; - Check it easy to turn over the crankshaft in bearings.
©2010-2017 Сайт Николая Русина.