REPAIR valve gear. Check the status of the rocker arms, and their axes
Before checking the wear of rockers and axles all the details
rinse in gasoline and clean.
Rocker is checked by the Inland dipmetru holes and
largest step on the cylindrical surface of the supporting heel.
The axis of rocker checked on the outside diameter. Valid
the wear holes in the yoke and shaft are shown in Table 2.
On the cylindrical surface of the heel of the supporting beam
allowed to wear no more than 0.05 mm (depth of groove
the middle). Therefore, the beam axis and having a wear of
allowed, replace with new ones.