SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR lubrication system.
Removal and installation of oil pump

The oil pump has a special case. Gear pump is working directly in the bottom of the bore drive sprocket covers timing. for disassembly pump enough unscrew the four screws fixing the cover oil pump, remove the lid and remove the gear from the bore. After disassembly, gear, and a cavity in the cover flush with kerosene and clean. Check the clearance between the diameter of the bore in the cover stars and an outer diameter of the gears. Odnovrenmenno provertezazor adjustment gears, which can be adjusted by adjusting the thickness of the gasket between the Oil pump cover with the plane of the lower sprocket covers. The quantities allowed clearances are listed in Table 2. After installing the sprocket gears to check their cover rotation. The gears should rotate freely by hand. When installing the bottom cover on the engine sprocket with the assembled oil pump drive gears splined shaft installed in any position.
©2010-2017 Сайт Николая Русина.