SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR lubrication system.
Checking the oil full-flow filter

When replacing an element each time change the rubber washers of the element and the rubber gasket glass. Especially check carefully the safety full-flow filter valve. For this purpose the valve body Remove the lid from the filter, disassemble, cleaning kernovku. If you wear a big ball valve, replace the last. The assembled valve must be tested on a special stand leak at the time of opening. In testing use industrial oil grade I-5A at 20 + 5 * C. The valve must open at a pressure of 0.9-1.1 kg \ cm2. With an open valve oil must flow continuous stream, and when the valve is closed only by individual drops. Check valves should be done very carefully, as the leaky valve can skip past the full-flow Filter the crude oil in the engine lubrication system. after check valve to prevent otvertyvaniya, zakernite thread at two points.
©2010-2017 Сайт Николая Русина.