REPAIR COOLING SYSTEM. Removal and installation of liquid pump
Removal of fluid pumps are manufactured in the following sequence:
- Drain the coolant from the cooling system;
- Remove the radiator;
- Open and loosen the nuts bolts holding the generator to
- Unscrew the bolt legs to the generator adjusting bracket;
- Move the alternator to the block, and remove the belt fan;
- Loosen the bolts and remove the fan;
- Unscrew the four bolts holding the nut to the bottom of the pump
sprocket covers and remove the pump.
Ustanovkku liquid pump in reverse
sequence. At the same time check the paper gasket
between the end flange of the pump and the plane of the support area on the bottom
cover the distribution of stars.
Damaged, replace the gasket of the new.
After installing the pump and adjust fan belt tension.