SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR OF SUPPLY AND EXHAUST GASES.
Carburetor Repair K-126N. Removal and installation of the carburetor

Dismantle the carburettor K-126N is made in such a sequence: - Loosen the clamp tube ventilation and oil sump, Loosen the screw with the lamb, anime air filter and gasket and washer from the neck; - Disconnect the fuel line from the kaobyuratora, tube vacuum regulator ignition, roller control throttle and choke control cable; - Unscrew the four screws holding the carburetor on the heels flange inlet pipe and remove the carburetor. Kapbyuratora installation in reverse sequence. At the same time pay attention to cleanliness carburetor flange surface and the integrity of paper pads stacked on insulating gasket and under it. Damaged gaskets replace. After installing the carburetor: - Check the throttle actuator rgulirovku valve carburetor and adjust if necessary drive; - Check the operation of the engine (in a hot condition) on mode, the minimum steady speed idle travel and, if necessary, adjust the carburetor so the engine worked steadily in the clutch. Moskvich-412
©2010-2017 Сайт Николая Русина.