SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

CLUTCH REPAIRS.
Control of key parameters with a press disk HOUSING ASSEMBLY

After you install and securely cover with the pressure plate assembly on a flat plate, replacing flywheel, with the planted under the pressure plate Stand-ring thickness T = 7.35 mm (Fig. 57), check the following. A. Radial run-out work surface supporting the heel, measured at 50 mm in diameter, shall noxtexceed 0.38 mm total indicator reading. In case of need to reduce the heel beats may be pressed or blow near one of the three sites A clutch housing. Two. Size M to be in the range 46.5-49.5 mm. Three. When moving the heel of the supporting surface P in the direction By the arrows on the 7.1 mm, changes in the surface of the P1 pressure plate in the direction of arrow H to be not less than 1.27 mm. 4. When applying to the surface of the supporting heel load P in the direction of the arrows to move away and the surface pressure-P1 drive from the surface of P2 on the surface of the beating of 7.9 mm A1 shall noxtexceed 0.25 mm. Measurement of vibrations and waste produce the pressure plate by means of indicators, pins are mounted on the head rivets meestah attachment to the pressure plate connectors. Five. The force required to move the surface P supporting the heel in the direction of the arrow K at 7.1 mm should be be no more than 82 kgs. In the measurement of the working force on the pressure plate mount on a flat plate. The force required to move P1 surface pressure plate in the direction of arrow H to position determined by the size of T, there should be no less than 340 kgs. In determining the working force on the pressure plate need to press the stem fell to as long as effort to stop decreasing and begin to rise. Then, reducing the burden, it is necessary to lift the rod to the position of the press pressure plate, corresponding to the size of D = 7.35 mm, and record in this case the actual load. Course pressure plate is measured by the indicator. If the data under the control of the validated parameters do not meet those standards, replace clutch cover assembly. WARNING! Instead of a spacer ring can be used three spacer washer thickness 7.35 mm, evenly spaced in a circle. The control effort is two-fold after the move surface of the heel of P in the direction of K to the provisions do not go beyond the maximum stroke 8.9 mm. Moskvich-412
©2010-2017 Сайт Николая Русина.