SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

CLUTCH REPAIRS.
REPLACEMENT CLUTCH BEARING

Necessary facilities and equipment to replace the bearing: Hand press, electric furnace or crucible. With a large work surface wear of the graphite bearing replace it. It is also possible replacement of the bearing assembly with a clamp (At the fork assembly). For this purpose, parts a special kit 412-1601953 - bearing clutch with the links in the collection. To change the worn bearing, proceed as follows. 1.Vypressuyte bearing of the cage, tapping a hammer on a wooden arbor, resting in the end bearing, or by using for this purpose, manual press. 2.Set clip bearing in an electric furnace (or cup) and heat it to a temperature of 240-250 ° C. 3.Set heated cage 2 (Fig. 66) bearing holder 3 press to bevel clamp for pressing the bearing was the top and by inserting xagraphite bearing a hole in the cage, zapressuyte until it stops. The working surface of the bearing in this case should not be be damaged (chipped, chipping, etc.). Cooling of the cage after assembly with the bearing should occur in the air. Wearing stamped on the trunnion yoke connecting links 8 (See Fig. 54), bearing clamp assembly set in a radial excavation clutch fork and secure it with these connecting links, which are installed rotation around the axis of the bearing holder pins to lock spring of the links in the ribs on the back of the curved grooves fork. It should be remembered that after the replacement of graphite bearings need setting the fork and clutch mechanism, free to adjust course of the outer end of the fork. Москвич-412
©2010-2017 Сайт Николая Русина.