SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR TRANSMISSION MECHANISM AND ITS MANAGEMENT.
REMOVAL OF TRANSMISSION VEHICLE (WITHOUT REMOVING THE ENGINE)

The sequence of operations when removing the gearbox with a car like that. 1.Vyvernite sump drain plug and fully Drain the oil from the gearbox. 2.Otvernite bottom nut shell a flexible drive shaft speedometer. 3.Razedinite ends of rods, levers within the floor mechanism. Freed tie rod ends to the power strip. 4.Ottsepite cable from the front of the intermediate lever the parking brake lever and remove the bracket from the car floor. 5.Snimite lower intermediate bracket bolt to the receiver tailpipe and loosen the upper bolt of the bracket to the bracket on the gearbox. Expand the bar. 6.Razedinite rear flanges universal joint, and shifting the shaft back, remove the plug before sliding universal joint with the shank of the secondary shaft of the gearbox and remove the driveshaft. 7.Podstavte at the rear of the crankcase, a wooden bar. 8.Snimite crossmember rear engine mounts, which loosen bolts cushion back support to the bracket on the extension cord and the cross member bolts to the bottom of the body. 9.Vyvernite bolts the transmission housing to the crankcase traction. 10.Podayte back and remove the gearbox from the car. When removing the gearbox, make sure that the input shaft nominated hub of the clutch disc simultaneously with the movement back the entire transmission. Installation of the box in the reverse order. It does not allow a sagging transmission on the slave drive adhesion to the occurrence of the input shaft bearing in the bore the clutch housing.
©2010-2017 Сайт Николая Русина.