SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR TRANSMISSION MECHANISM AND ITS MANAGEMENT.
DISASSEMBLY PRIMARY AND SECONDARY SHAFT

The sequence of operations during disassembly of the shaft such nepvichnogo. 1.Snimite snap ring input shaft bearing special mites, which have projections) for opening his ring. Upon removal of the ring using forceps should not overtax, since excessive deformation of the ring loses its elasticity and can not be used again. If the puller is missing, the locking ring to be lifted by two screwdrivers. 2.Spressuyte bearing shaft, using this manual press and a mandrel. 3.Snimite snap ring with the bearing shaft, using special forceps having protrusions to pull the ring. At no ring can be removed from the bearing pomoschyo screwdriver. 4.Snimite snap ring with an awl and remove it mainshaft needle bearing front output shaft. The sequence of operations during disassembly of the secondary shafxtextension as follows. 1.Otvernite bolt by turning the speedometer gearbox, remove it from the extension. 2.Set the output shaft 5 (Fig. 79) rear end enshrined in the slotted cup 7 and loosen the nut 1, pre razognuv lock washer. 3.Snimite using a puller (Fig. 80) with the output shaft 10 hub with a clutch two inclusion treretey and fourth gears. At the absence of a stripper this operation can be performed using two screwdrivers, which should be inserted between the gears third and second gears 4. 4.Snimite with hub remover 6 5 gear transmission back stroke. This operation can also be made by two screwdrivers, institutions in the space between the end of extension 9 and 7 gears first transmission. It should take measures to avoid deformation of the end of an extension cord that can be achieved by using a large screwdriver or with pads. 5.Spetsialnymi tongs remove the snap ring average bearing output shaft and light strikes a wooden block the rear end of vtorichngo knock out shaft shaft assembly with the bearing of the extension. 6.Snimite with the output shaft snap ring and leading speedometer drive gear. Further attacks on the wooden slats secondary shaft knock the ball-lock gear out of the hole shaft. 7.Ustanovite secondary shaft front end on a wooden block and through the pipe, simply supported on the inner ring of the bearing, compress the bearing 8 with the output shaft 10. 8.Vypressuyte from the mouth of an extension cord (Fig. 81), two cuffs, spolzuya for this special puller. If the cuff to be replaced, they can be removed with a screwdriver. Москвич-412 Москвич-412 Москвич-412 Москвич-412
©2010-2017 Сайт Николая Русина.