SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR TRANSMISSION MECHANISM AND ITS MANAGEMENT.
DISASSEMBLY AND ASSEMBLY Gearshift

The sequence of operations such razborochno. 1.Install mechanism in the device shown in Fig. 82 and 83. Rasshplintovav and removing the nut 11 (Fig. 84), carefully shake a finger 13 of the lower lever switch and remove the lever 8. 2.Otvernite seven screws fastening the bracket 14 of the lower arm control switch. Remove the bracket and remove the stress 28 reverse gears with springs. If the emphasis between the reverse gear and the plate bracket Shims will be at the assembly mechanism All pads must put in place. 3.Otvernite nut 4 and the copper wedge knockout knock out three of the lever switch gear and remove the lever. 4.Ustanovite cover 7 (Fig. 85) adaptation, two razognuv stopper arm shaft nuts switch, unscrew the screws 3 and remove the bracket 4 focusing lever reverse gear. 5.Vynte of the lid locking switch with an 8 transfers to and from ring groove sleeve 22 (see Fig. 84) 21 collar. Fist of the switch is pressed to the transmission shaft and, in addition, welded (nonseparable combination of these parts). The assembly mechanism gear in reverse sequence given the following instructions. 1.When mounting sleeve make sure it is completely housed in the groove bushings (without gaps). 2.Pereklyuchatel gear is mounted in the cover along with the wearing it fork lock. When mounting the switch gear, pay attention not to damage the cuff. The rubber cuff-scraper should be wearing a pressed cage guillemot. 3.Rychag gear selector is put into focus on the end of the shaft switch gears. Threaded end of the lever valve mounting switch gears on the shaft should be pointing down. 4.After tightening the screws mounting bracket shaft switch ensure easy movement, together with the lock switch. Then bend the lock nuts on the brink. 5.Razvaltsovku brass shell casings in the rubber control arm bushings made with special forceps. 6.Regulirovka side cover comes down to, to ensure gap a = 0.15-0.35 mm (see Fig. 84) between the lower arm 8 and focus 28 reverse gears when installing cam switch 18 with respect to transmission end cover 1 in position h = 3,5 mm. Adjustment is made with 23 goals, laid between the focus and the plate bracket 14. Москвич-412 Москвич-412 Москвич-412 Москвич-412
©2010-2017 Сайт Николая Русина.