SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

Propshaft

Propshaft is composed of two cardan joints (universal joints) with needle bearings, tubes 9 (Fig. 96) PTO shaft and flange sliding forks.

DETERMINATION OF TECHNICAL Propshaft

In cases of complete or partial disassembly of driveline recommended to check the status of parts universal joints: spines crosses, needle bearings and bearing seals and if necessary, replace them. Spikes spider should not have dents (brinelirovaniya) of the needle bearing rollers. In the presence of smooth working surface diameter of the spine as a result of wear and tear should not be less than 15.17 mm. Rollers should not have any visible signs of wear. TROUBLESHOOTING Propshaft and troubleshooting -------------------------------------------------- --------- Cause of Failure and the Solution -------------------------------------------------- --------- Noise and Vibration driveshaft The deformation of the propeller shaft ................................ Remove the drive shaft .........................., to straighten press, a large deformation sbalansiruyte.Pri replace the shaft The increased imbalance of the propeller shaft ....................... Remove the drive shaft .........................., balance Loosening of the propeller shaft to the flange of the rear axle .. Tighten the nut torque .......................... key, torque 2-2.5 kgssm Worn bearings cardan joints and spines frogs ....... Replace .......................... crossbar with ball bearings, balance the shaft Loosening of the rear support the power plant .......... Tighten bolts .......................... cross back support knock on the propshaft, found in the trough-Research Institute of the car from the place when you switch gears when a vehicle is inertia, or a sharp increase in the speed of the motor shaft Worn bearings cardan joints and spines frogs ....... Replace the crossbar with .......................... bearings, balance shaft leaking oil through the plug sliding fork The weakening of planting plugs .................................. Seal cap ............................ embossed or opayayte landing stubs Москвич-412
келикс
©2010-2017 Сайт Николая Русина.