SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REPAIR Propshaft
DISASSEMBLY driveshaft

To save the running-in of mating parts and ensure minimal changes in propeller imbalance shaft, the inevitable when it is built, before disassembly mark the mutual arrangement of parts cardan joints, to the assembly to install them to their former places. Dismantling in the following order. A. Light hammer blows through the copper or aluminum Tap the bottom of the mandrel body (cup) each needle bearing and remove with a screwdriver retaining rings 20. Two. Place the device in the cardan joint, so that lower ear plugs 3 {Fig. 97) relied on supports 1 and through the press, pressing through the bracket 4 and fork PTO hinge vypressuyte needle bearing from the bottom eyelets. Then rotate the gimbal joint at 180 °, reinsert in the fixture and in such a way vypressuyte second bearing the same fork. 3.Razedinite fork universal joint. 4.Nadente needle bearings on the loose spikes spider, Plug in the device so that the lower eye relied on supports 1 and with the press, pressing through the bracket 4 and the bearing housing on the crossbar, vypressuyte bottom, and then the upper bearings. 5.Snimite with cross needle bearing sleeve. Москвич-412
©2010-2017 Сайт Николая Русина.