Driveshaft assembly make in this
sequence.
1.Install the thorns cross needle cuffs
bearings and with the help of the press and two cylindrical
bars (Fig. 98) zapressuyte in pairs all the way
collars at the crossing.
2.Zapolnite full lubricant holes
Crossings.
3.Smazhte lubricant needle rollers
bearing.
4.Vstavte crossbar with cuffs in one of the forks.
5.Pomestite plug in the device (Fig. 99), zapressuyte
in her eye needle roller bearings, and then
retaining rings. In this way the rest zapressuyte
two new bearings in the eyelets, and then plug the other
retaining rings.
6.Proverte cardan fork ease of movement, which
should be free from the hand without sticking to move at an angle
not less than 15 ° in any plane.
7.Sbalansiruyte shaft dynamically. Acceptable balance for
both ends of the shaft 15 g * cm