SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

TROUBLESHOOTING rear axle and methods of their elimination

Cause of Failure Solution -------------------------------------------------- ----------- Leak of lubricant through the sleeve pinion Wear cuff .......................................... Replace the cuff ........................... Depreciation is the hub flange mount rear end of the driveshaft shaft ................................................. .. Replace Flange ........................... lubrication of brake drums and linings pads Wear cuff axis .................................. Replace the cuff ........................... Elevated levels of noise at work rear axle Deterioration or destruction of pinion bearings ...... ........................... Replace worn or damaged bearings Deterioration or destruction of the differential bearing box .. Adjust the preliminary ........................... differential bearing preload the box and replace Bearings Worn gear teeth main gear .................. Adjust the side clearance ........................... gears or change gears The increase in the lateral clearance between the gear teeth the main transmission ............................................ Adjust the side clearance ........................... Gear knock, listening only when the vehicle is coasting The weakening of landing back hinge mounting flange propeller shaft ........................................ ........................... Tighten nut flange to the drive gear knock on the part of the brake drum Deterioration or failure of the bearing axis of rear axle ... Replace the axis ........................... complete with bearing or just bearing knock on the part of the brake drum with weak drifts, in side of body roll or the shocks from right to left and back Bearing axial clearance in the socket housing flange back bridge or half-axial clearance in the bearing due to the reducing valves and plugs ................................ ........................... In the first case, remove the axial the gap with steel gaskets, setting them between the the bearing outer ring and the inner end face of the nest, or Tighten the four screws that secure the brake plate and screw. In the second case, replace the axle assembly knock at the change in the transmission mode of motion Wear gear differential and the increase in the gap meshing gears of the main transfer ...................... Replace differential gear ........................... or adjust the backlash of the gears with steel pads, placed under the ends of pinion axis. Adjust backlash gear and main gear Tighten the differential bearing boxes Irregularities in the engine ................................ Adjust the engine ........................... continuous whistling noise while driving Faulty bearings pinion final drive ... Replace bearings ........................... When adjusting the backlash the original installation the size of the pinion must be maintained.
©2010-2017 Сайт Николая Русина.