SITE OF NICHOLAS RUSIN -

- PAINTING, SCULPTURE, PROSE AND MORE WHAT THAT


MAIN


LEAVE YOUR COMMENTS
ON THE PAGE OF OUR FORUM

Rare-OLD CARS

MOSKVICH-412

Сайт для инженеров и механиков

REMOVING THE REAR AXLE SEMI-AXIS
CHECKING THE STATUxsaxis and mating parts

REMOVING THE REAR AXLE SEMI-AXIS Removing the half can be made on the car without removing the rear axle. Removal Procedure axis is described above in Sec. "Removing and installing rear axle, "pp 1-3 and" Disassembly and assembly of the rear axle " pp 1-3. CHECKING THE STATUxsaxis and mating parts Check out the technical state of details included in the kit half, and make sure the following. 1.Sharikopodshipnik not frayed or damaged (if the radial clearance in the bearing exceeds 0.1 mm, the bearing should be replaced). 2.Zapornaya and hard bushings and bearings do not wear a name, injury and did not receive offsets from the original landing sites. 3.Prizhimnaya plate bearing is not damaged. 4.Poluos not deformed, seating surfaces and splines not damaged and no increase in wear. If wear or damage is detected axes or parts mounted on the axis, they must be replaced.
©2010-2017 Сайт Николая Русина.