The easiest way to stop removal of a hub groove
its outer diameter. You can also milled or
gash on the cylindrical surface of the wrench flats. At the same bush
weakened and easily comes off with a half-line.
You can remove it with a bearing on a hydraulic press.
For this purpose between the plate 1 (see Fig. 100) bearing mounting
and the bearing insert a plate thickness of 4-5 mm, or special
semiring, and bearing cover. Opera on the rings
stand, or traverse the press, the press rod from the spline
end vypressuyte axis.
Check whether the axis of injuries.
If necessary, replace the new axis.
Repeated use of the locking sleeve is not allowed.