Disassembly of the main gear is recommended
on a special stand in the device.
If you stand or device available, disassembly and reassembly
main gear can be carried out in a vise. At the same time secure
Home for the transmission oil drain edge of the tide for the channel
The sequence of operations on a main transmission disassembly.
1.Otvernite bolts and remove the stopper adjusting nuts
differential bearings. Mark the bearing caps differ,
if they are not labeled. Remove the bolts,
securing the differential bearing caps and remove the cover. Remove
adjusting nut and the differential with the driven gears and bearings.
2.Otvernite nut flange to the pinion shank.
3.c using puller remove the mounting flange of the propeller shaft
4.C a rubber mallet or the emboss leading
gear with the bearing inner ring it with a spacer
and shims, keeping in this hand gear
for her head.
5.Ustanovite sump on a special stand (Fig. 105.106)
neck down and with the help of the mandrel 2 vypressuyte outer ring
simultaneously with the front bearing plate and maslootrazhatelnoy
6.Vypressuyte outer ring 2 (Fig. 107) with the rear bearing
Using a special, introduced through the same ring mandrel 1.
Remove the shims.
7.Snimite with the pinion shims, and spacer
Remove the hand press on the inner ring 4 (Fig. 108), rear
bearing, using a special stand consisting of two
two cylinders, connected by a ring.